Original Smooth On XTC 3D untuk Finishing Hasil Print 3D dari USA

Original Smooth On XTC 3D untuk Finishing Hasil Print 3D dari USA


XTC-3D™ is a protective coating for smoothing and finishing 3D printed parts. Two liquids are mixed together and brushed onto any 3D print. Coating self-levels and wets out uniformly without leaving brush strokes. Working time is 10 minutes and cure time is about 4 hours (depending on mass and temperature). XTC-3D™ cures to a hard, impact resistant coating that can be sanded, primed and painted. Adding colors and metal effects is easy. Inexpensive to Use – 1 oz covers 100+ square inches (see coverage information below).

90% Time & Labor Savings: XTC-3D™ fills in 3D print striations and creates a smooth, high gloss finish. The need to post finish is almost eliminated.

Coat any 3D Print Surface - XTC-3D™ can be applied to both SLA and SLS prints. It works with PLA, ABS, Laywoo, Powder Printed Parts and other rigid media. It also can be used to coat EPS, EPDM and urethane foam as well as wood, plaster, fabric, cardboard and paper.

XTC-3D™ does not contain VOC’s, phthalates or phosphates.

Berat Isi : 644 Gram



Murah dan mudah untuk dipakai
Hanya pakai sedikit untuk menghaluskan hasil 3D Print anda
25 gram bisa dipakai untuk area 30x22 cm